Blog

What To Look For When Buying JIC Fittings

If you are involved in an industry that works with high levels of pressure, such as the fuel industry, then you might be familiar with JIC fittings. These seemingly simple fittings are often used to help with preventing pressure, moisture and more from escaping from hoses and tanks, and you may use them on a wide range of equipment within your industry. Even though you might use a lot of these fittings, you might not be particularly familiar with purchasing them.

3 Tips For Storing Copper Tubes For Your Factory's Machine Shop

If you factory has recently ordered a load of copper tubes for use in your machine shop, you may be uncertain as to how to store them properly. If so, use the following tips for storing the tubes until you need them for your next project. Select a Dedicated Spot for the Copper When deciding on the location for the copper tubes, select a spot that will be dedicated only to them.

5 FAQs About Scrap Metal Recycling

If it's been a while since you've cleaned out your garage, or if you are simply working on a major construction project, you may have some free money lying around disguised as junk. Scrap metal recycling companies will take your scrap metal and give you money. If you aren't sure if scrap metal is worth the time, check out these five frequently asked questions. What Does Ferrous Metal? When you start research scrap metal recycling, you may see the term ferrous.

Your Lathe Workstation: Setup Essentials

Working with metal often involves a skillset that people need to learn and practice before they are confident about their work and good at what they do. If you're working with powerful machines like lathes which need to be handled properly to avoid injury and damage, you'll also need a sensible setup and workstation. Workstation suggestions launch as those below are essential for doing your best work. Use a Turning Tool Holder

Developing New Machining Processes

When you are trying to take your machining to the next level, it is important to consider that there might be machining methods that you have not yet thought of. One of the major aspects of machining is the act of removing material. There is an object, such as a piece of metal or plastic. Then, material that is a part of this object is removed. For example, if a hole is drilled into an object, a hole is not created necessarily, but the material that used to fill the hole was removed.